2008 Winnebago Sightseer electic question

[Grunt13]

Have 2 slides. Bedroom slide works great. Front room slide with couch has voltage to key switch for slide. This slide has two motors. does anyone know if there are separate relays and if so their location. Note: I swapped out the "IN and OUT" control panel and still only the bedroom slide works. We did have a lot of snow and rain this winter but last time we used the front room slide it worked. I checked all fuses. WIRING DIAGRAM is very difficult to read. Thanks

[JPeterson]

There is a controller for each slide. If I remember correctly, my bedroom slide is in basement compartment rear of the door and living room slide is behind electric panel in compartment in front of door.

[Grunt13]

Thank You very much. I will get back into.

[Grunt13]

The controller module was faulty on the double motor slideout for the living room. It is located above the propane storage compartment forward the steps. The modules, (2 of them) one for bedroom slide and one for living room slide are located behind the circuit breaker panel in the same compartment as the propane. Thanks for the help.

[robertallan]

I also have a 35j (Sunova) and dealing with a main slide issue. I am going to search for the living room module behind the panel above the propane tank. How did you the controller modules? I search about everywhere and found nothing about the modules. Do you have the Kwikee digisync Slides?