Awning Wind Sensor Problem

[Sammie]

I know this issue has been covered several times before in this forum, but I am having problems with the wind sensor causing my control box to beep. I have turned the sensor switch to the disable position to stop the beeping for now. My sensor is the older style located on the roof. Does A&E just replace the roof sensor or do they upgrade to the newer style located in the awning arm?

[Sammie]

I know this issue has been covered several times before in this forum, but I am having problems with the wind sensor causing my control box to beep. I have turned the sensor switch to the disable position to stop the beeping for now. My sensor is the older style located on the roof. Does A&E just replace the roof sensor or do they upgrade to the newer style located in the awning arm?

[Hitchhiker]

Sometimes they'll beep in real cold weather... it's the nature of them. But I see you're in Southern California so that's probably not applicable to your situation.

[The Sunde's]

Like Richard, I had read in previous post that the controler would beep during cold weather when set on automatic to protect the awning. Sure enough two days later I was out side and could hear beeping. The light over my head came on and I looked at the awning control panel and sure enought it was beeping. I turned it off and it stopped. Temp? In the 30's. Maybe you had a cold snap and it set it off. No sure if it reset itself when it warms back up.
Hope this help.