|
08-10-2018, 11:31 AM
|
#1
|
Senior Member
Join Date: Jan 2017
Posts: 7,494
|
Driven half mad by screen door
Hi,
The screen door on my 2008 Itasca Latitude is damn noisey, it shakes and rattles.
I have tried door/window draft foam to no avail.
Winnebago reckons the screen door maybe be bent. I am half tempted to remove the screen door.
Any ideas?
Thanks,
__________________
2008 Phoenix Cruiser 3100
2012 Jeep Wrangler Sahara JKU.
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
08-10-2018, 11:45 AM
|
#2
|
Senior Member
Winnebago Owners Club Ford Super Duty Owner
Join Date: Dec 2009
Posts: 2,529
|
Have you found out exactly where the rattle is coming from? I have the same problem and just wadded up some plastic trash bags to shove behind the screen door sliding cover that goes over the latch...quiet as can be now. (The real fix would be to re weld the track so it's firm in the frame but who's going to do that?). Have someone sit close by when you drive to pin point the area that rattles.
__________________
2008 Winnebago Sightseer 35-J
|
|
|
08-10-2018, 12:07 PM
|
#3
|
Senior Member
Join Date: Feb 2002
Location: bel air, md
Posts: 822
|
Screen door
I used black silicone from harbor freight around the panel where the slide is and that made a big difference.
__________________
09 Winnie 32 h adventurer towing '18 Malibu
|
|
|
08-10-2018, 12:23 PM
|
#4
|
Senior Member
Join Date: Jan 2017
Posts: 7,494
|
Thanks Puttin,
Its definitley not the sliding cover as I removed it after a buddy sat by the door.
Thanks Billy,
I will check out that.
__________________
2008 Phoenix Cruiser 3100
2012 Jeep Wrangler Sahara JKU.
|
|
|
08-10-2018, 12:42 PM
|
#5
|
Senior Member
Winnebago Owners Club Ford Super Duty Owner
Join Date: Aug 2016
Location: Northern VT
Posts: 471
|
On mine, there are several rubber "bumpers" on the side of the screen that push up against the door when the two are pushed together. Several of mine were old enough that the rubber had turned hard and thus was squeaking, always sounded like sneakers on a gym floor but worse.
Only other things I've noticed, door needs to be shut tight, both locks on and the "slider" on the screen door slid all the way shut or guaranteed noise........
__________________
2015 Winnebago Vista 35B. "The Vistabus!!"
|
|
|
08-10-2018, 12:45 PM
|
#6
|
Senior Member
Join Date: Jan 2017
Posts: 7,494
|
Hi Blastvale,
The rubber bumpers on mine are a bit worn, I did put some draft strips over it. I will get new pads. I only ever lock one lock. Will try both :-)
__________________
2008 Phoenix Cruiser 3100
2012 Jeep Wrangler Sahara JKU.
|
|
|
08-13-2018, 01:09 PM
|
#7
|
Senior Member
Join Date: Jan 2017
Posts: 7,494
|
It seems to be the latch is not tight either.
__________________
2008 Phoenix Cruiser 3100
2012 Jeep Wrangler Sahara JKU.
|
|
|
08-13-2018, 05:46 PM
|
#8
|
Senior Member
Join Date: Jan 2017
Posts: 7,494
|
__________________
2008 Phoenix Cruiser 3100
2012 Jeep Wrangler Sahara JKU.
|
|
|
08-13-2018, 07:41 PM
|
#9
|
Senior Member
Newmar Owners Club Spartan Chassis
Join Date: Apr 2015
Location: Dallas, TX area
Posts: 634
|
I used clear caulking around the lower panel screen protector as it was loose and seemed to set up a harmonic that was making me nuts.
Also, I swing the screen door handle to the closed/locked position while driving. That seems to keep the door from making a rattling noise. The combination of both fixes has worked well for several years.
I tried to tighten the door handle and that did not work at all.
|
|
|
08-14-2018, 05:56 AM
|
#10
|
Senior Member
Join Date: Jan 2017
Posts: 7,494
|
Thanks Don,
I will try getting the latch in to the lock position.
__________________
2008 Phoenix Cruiser 3100
2012 Jeep Wrangler Sahara JKU.
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Thread Tools |
Search this Thread |
|
|
Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|