Join CruisersForum Today
Mission Statement: Supporting thoughtful exchange of knowledge, values and experience among RV enthusiasts.
Reply
  This discussion is proudly sponsored by:
Please support our sponsors and let them know you heard about their products on iRV2
 
Thread Tools Search this Thread Display Modes
Old 08-18-2008, 07:23 PM   #1
Boris and Natasha is offline
Senior Member
Winnebago Owners Club
Freightliner Owners Club
Join Date: Jun 2008
Location: Anywhere, USA
Posts: 154
We spent the weekend camped in the Sacramento River delta, which is known to be windy...especially in the summer. This weekend did not disappoint in that department, so we were parked in a hefty crosswind aimed straight at our full-length slide all weekend. The steady breeze, which we estimated was 15-20 mph with gusts to 35-40 mph or so, would cause the slide topper on that 23-foot slide to bulge up, then rapidly retract. (Imagine the noise inside. Not fun!) Needless to say, we spent most of the weekend with the slide retracted. We didn't want to risk hearing the slide topper rip and seeing it go flying.

Cruising 'round the campground, we saw several slides and toppers pointed the same direction as ours that didn't move an inch in the stiff delta breeze. But, to be fair, not one of them was anything close to 23-feet long.

We're wondering a couple of things: If you're camped with a crosswind aimed at your slide, what windspeed would cause you to pull your slide in? And, can slide toppers be adjusted to stay taut in a crosswind?

We're newbies at all this....your expertise is warmly welcomed.

Thanks,
Natasha

__________________
Our sidekicks: Bullwinkle, our 2009 Winnebago Tour 40TD, and Rocky, our 2005 Jeep Wrangler
Fulltime since July 2009
  Reply With Quote
   
Join the #1 RV Forum Today - It's Totally Free!

iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!

You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!

Old 08-18-2008, 07:23 PM   #2
Boris and Natasha is offline
Senior Member
Winnebago Owners Club
Freightliner Owners Club
Join Date: Jun 2008
Location: Anywhere, USA
Posts: 154
We spent the weekend camped in the Sacramento River delta, which is known to be windy...especially in the summer. This weekend did not disappoint in that department, so we were parked in a hefty crosswind aimed straight at our full-length slide all weekend. The steady breeze, which we estimated was 15-20 mph with gusts to 35-40 mph or so, would cause the slide topper on that 23-foot slide to bulge up, then rapidly retract. (Imagine the noise inside. Not fun!) Needless to say, we spent most of the weekend with the slide retracted. We didn't want to risk hearing the slide topper rip and seeing it go flying.

Cruising 'round the campground, we saw several slides and toppers pointed the same direction as ours that didn't move an inch in the stiff delta breeze. But, to be fair, not one of them was anything close to 23-feet long.

We're wondering a couple of things: If you're camped with a crosswind aimed at your slide, what windspeed would cause you to pull your slide in? And, can slide toppers be adjusted to stay taut in a crosswind?

We're newbies at all this....your expertise is warmly welcomed.

Thanks,
Natasha

__________________
Our sidekicks: Bullwinkle, our 2009 Winnebago Tour 40TD, and Rocky, our 2005 Jeep Wrangler
Fulltime since July 2009
  Reply With Quote
   
Old 08-19-2008, 02:12 AM   #3
Ding-a-ling is offline
Senior Member
Ding-a-ling's Avatar


Winnebago Owners Club
Workhorse Chassis Owner
Join Date: Aug 2004
Location: Zephyrhills, FL
Posts: 883
Natasha,

Look through These posts regarding the anti-billow device.

I had a similar experience last October while driving in a 35 - 40 MPH gusty crosswind. I found the rivet missing that should secure the bracket to the end of the hexagonal bar mounted on the slide. Wind would get under the roll of the topper and cause the end bracket to twist on the hexagonal bar. When the spring tension overcame the wind there was a big THUMP

While at the factory for other repairs, I told them about this trouble. Their fix was to place 1/2" spacers under the slide topper mounting plates on the side wall of the slide out. In looking around at other MHs since this repair, I find older rigs have plate mounted directly on slide wall - newer rigs have this spacer under mounting plate.

I hope this helps.
__________________
'05 Itasca Suncruiser 38R, '04 Saturn VUE
BlueOx Towing Pkg, WH W24, UltraPower Upgrade
49 States & 7 Provinces visited in MH| WIT W112365
  Reply With Quote
   
Old 08-19-2008, 04:30 AM   #4
John_Canfield is offline
Senior Member
John_Canfield's Avatar
Join Date: Jan 2005
Location: Back at the ranch
Posts: 2,540
Ours essentially wore out after three years of lots of use (we fulltimed for over a year) in very windy conditions for much of that time. I have always been reticent about pulling in slides due to weather, and the one time we did, our street-side living room topper had a 1/4" coating of ice and wow what a noise it made on retraction.

I thought for sure it was ruined, but it wasn't.

Consider your toppers an expendable and enjoy the rig.
__________________
--John

2005 Horizon 40AD, 2005 Jeep Liberty CRD
  Reply With Quote
   
Old 08-19-2008, 05:18 AM   #5
Wayne M is offline
Senior Member
Wayne M's Avatar


Winnebago Owners Club
Texas Boomers Club
Freightliner Owners Club
Join Date: Aug 2008
Location: Texas
Posts: 4,555
Although 23' is a good distance for this, carry a 2 1/2 or wider flat strap that will fit across the middle of the topper. Attach a rope where the strap overlaps the topper on each end. at the bottom of each rope, place a good quality bungee and attach it to the underneath frame and adjust the tension on the rope for a comfortable pull, not extensively tight. This will relieve the flapping to a great extent. Don't forget to remove the strap prior to retraction (Another check list item)

I would not construe this to be a permanent fix, but a temporary one when you are on the road and cannot get the tension fixed until you get back. Most auto stores or sports stores (Academy) have flat straps.

DO NOT use a rope or narrow strap across the topper as it will act as a knife and cut through the fabric where it goes over the edge. Wider is better.
__________________
Wayne MSgt USMC (Ret)
2008 Destination 39W
  Reply With Quote
   
Old 08-19-2008, 06:12 PM   #6
David K is offline
Senior Member
Join Date: Nov 2006
Location: Grayson, GA
Posts: 722
John

I agree with you. I have a 2002 Ultimate Advantage and the slide topper on my living room slide out gave up the ghost this past weekend. The spring in it broke. The sides were becoming frayed with use also. I bit the bullet and ordered a new one from Carefree of Colorado (that is the one that I had on the coach). I had to replace the one on the bedroom slide this past winter -- broke spring on it also. Both of the new ones are the types that are enclosed in the full case when not extended -- helps to prevent any "billowing" when traveling down the road.
__________________
Dave and Karen
02 Ultimate Advantage36C / Cummins 350 HP ISC
07 Focus 4 Down Road Master Brake Master 4160
  Reply With Quote
   
Old 08-20-2008, 04:43 PM   #7
David K is offline
Senior Member
Join Date: Nov 2006
Location: Grayson, GA
Posts: 722
The shipping of the slide topper "blew me away" --- I ordered late Monday afternoon and it was delivered today. Took about 2 1/2 hours to take off the old one and put the new one on. Looks great and now the front and back match.
__________________
Dave and Karen
02 Ultimate Advantage36C / Cummins 350 HP ISC
07 Focus 4 Down Road Master Brake Master 4160
  Reply With Quote
   
Old 08-21-2008, 03:14 PM   #8
John_Canfield is offline
Senior Member
John_Canfield's Avatar
Join Date: Jan 2005
Location: Back at the ranch
Posts: 2,540
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by David K:
The shipping of the slide topper "blew me away" --- I ordered late Monday afternoon and it was delivered today. Took about 2 1/2 hours to take off the old one and put the new one on. Looks great and now the front and back match. </div></BLOCKQUOTE>Wow - customer service doesn't get any better Kudos to you for wrestling with your topper and replacing it yourself!
__________________
--John

2005 Horizon 40AD, 2005 Jeep Liberty CRD
  Reply With Quote
   
Old 08-28-2008, 03:15 AM   #9
MarkCinCLT is offline
Member
MarkCinCLT's Avatar
Join Date: Jul 2007
Location: Charlotte, NC
Posts: 30
We bought a 2-year old coach and had all three slide toppers replaced (at Camping World) due to rotted fabric. New fabric has been on exactly 48 weeks and one is already rotting again. Fortunately, it is still under Dometic's 1-year warranty. I'm sure Dometic will find some excuse NOT to cover it, but we'll see.

On a similar topic: It appears that Winnebago FINALLY (hurray!) dumped AE/Dometic awnings for Carefee on the 2009 models.

__________________
Mark in Charlotte, NC

2005 Itasca Horizon 40AD
  Reply With Quote
   
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Slide Woes OregonLuvr Winnebago Industries Owner's Forum 7 06-23-2008 06:46 AM
Slide topper Captain Bud Northeast Region 2 10-29-2007 12:07 PM
Power Gear Slide adjustment, on Livingroom/Diningroom slide Ragman MH-General Discussions & Problems 4 09-30-2007 11:08 AM
Why no slide topper on kitchen slide? N8iveTexanMaverick Newmar Owner's Forum 7 08-30-2007 01:58 PM
steering box adjustment needed duner bill MH-General Discussions & Problems 4 07-28-2006 04:44 PM

Download our Mobile App






1% for the Planet
» Upcoming Rallies
No events scheduled in
the next 365 days.
» iRV2 on facebook

Our Communities

Our communities encompass many different hobbies and interests, but each one is built on friendly, intelligent membership.

» More about our Communities

Automotive Communities

Our Automotive communities encompass many different makes and models. From U.S. domestics to European Saloons.

» More about our Automotive Communities

RV & Travel Trailer Communities

Our RV & Travel Trailer sites encompasses virtually all types of Recreational Vehicles, from brand-specific to general RV communities.

» More about our RV Communities

Marine Communities

Our Marine websites focus on Cruising and Sailing Vessels, including forums and the largest cruising Wiki project on the web today.

» More about our Marine Communities


Copyright 2002-2012 Social Knowledge, LLC All Rights Reserved.
All times are GMT -6. The time now is 12:17 AM.