 |
08-16-2010, 12:48 PM
|
#1
|
|
Senior Member
Mid Atlantic Campers
Join Date: Oct 2007
Location: Allentown, PA
Posts: 367
|
Hi Guys:
Just got back from a 600 mile RV trip. Sometimes my Entrance door squeaks so bad driving down the road it drives me nuts. I tried shutting it harder, put the locks on, and so on.
Is there any tricks that I am missing that could some how make the squeaking go away or tighten it up some how?
Regards... Jim P.
__________________
Meridian 2004 36G DP
2010 Jeep Sahara Unlimited
Two HD's for company
|
|
|
|
| |
|
 |
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
08-16-2010, 03:35 PM
|
#2
|
|
Senior Member
Join Date: Apr 2006
Location: Highlands Ranch, Colorado
Posts: 268
|
Try the o'l black electrical tape around the bolt--just a couple of turns. If it works you will have to replace it every once in a while--but it's cheap!! It is the only fix I could find that works. I put a Teflon bolt on my 2002 Journey but it finally started to squeak again and back to the tape. Good luck--John
__________________
John and Marion Bell
Highlands Ranch, Colorado
2009 Winnebago 30B Sunstar, Ford F-53 / V-10
|
|
|
|
| |
|
08-16-2010, 04:07 PM
|
#3
|
|
Senior Member
Join Date: Apr 2009
Posts: 112
|
I sprayed WD-40 all along the door seams where the door moulding meets the oouter walls...that seemed to do it for a season..You can also spray it on the inside wall seams....RKL
__________________
2002 Journey 36GD, Roadmaster Blackhawk tow system, 2006 Jeep Commander Hemi, 2005 Jeep Wrangler...Webster NY/Ft Myers Fl.
|
|
|
|
| |
|
08-16-2010, 05:33 PM
|
#4
|
|
Senior Member
Workhorse Chassis Owner
Join Date: Aug 2007
Posts: 214
|
My squeak was more of a road noise/wind whistle from the lower seal of the door. a 1/2inch wide self adhesive rubber foam applied along the bottom edge stopped it all.
__________________
04 Allegro 30DA, WH 8.1, Banks, 03 Honda CRV, Blue Ox Aladdin, Brake Buddy Adv. Select,
300watts Solar, 7 Group 31 Optima AGMs, 2000watt PSW inverter
 "Philippians 4:11"
|
|
|
|
| |
|
08-16-2010, 06:33 PM
|
#5
|
|
Senior Member
Join Date: Feb 2005
Posts: 137
|
I've stopped my squeaking when it happens by spraying & wiping down the gaskets with 303 Aerospace Protectant. Usually lasts for a few months.
__________________
Fulltiming in a 2006 Ellipse 40FD
Our blog
|
|
|
|
| |
|
08-16-2010, 07:35 PM
|
#6
|
|
Senior Member
Mid Atlantic Campers
Join Date: Oct 2007
Location: Allentown, PA
Posts: 367
|
Thanks Guys:
I will look at the bolt assembly and try WD-40 around the hinges.
Sure as heck can't hurt.
Regards.. Jim P
__________________
Meridian 2004 36G DP
2010 Jeep Sahara Unlimited
Two HD's for company
|
|
|
|
| |
|
08-16-2010, 07:40 PM
|
#7
|
|
Senior Member
Winnebago Owners Club
Join Date: Jun 2006
Location: Southern California
Posts: 1,015
|
Quote:
Originally Posted by bellsharbor
Try the o'l black electrical tape around the bolt--just a couple of turns. If it works you will have to replace it every once in a while--but it's cheap!! It is the only fix I could find that works. I put a Teflon bolt on my 2002 Journey but it finally started to squeak again and back to the tape. Good luck--John
|
The black tape trick works so good I can't believe it.
Sammie
__________________
2006 Journey 36ft, Cat C7
2008 Jeep Grand Cherokee
" A Job Begun is Half Done "
|
|
|
|
| |
|
08-16-2010, 07:45 PM
|
#8
|
|
Community Moderator
Join Date: Jan 2007
Location: Litchfield Park, Arizona
Posts: 5,151
|
WD40/Silicone spray helps a lot with mine but I also get something which is more of a "sqawk" from the door while driving that drives me up the wall. Somewhere on this forum are threads which I think refer to spraying an expanding foam behind the plastic door panel and if I'm not mistaken it was 3 Ts RV near Las Vegas who was doing it but.... I'm old... I forget stuff.
__________________
Rick, Nancy, Peanut & Lola our Westie Dogs & Bailey the Sheltie.
2007 Itasca Ellipse 40FD
|
|
|
|
| |
|
08-16-2010, 08:09 PM
|
#9
|
|
Senior Member
Winnebago Owners Club Freightliner Owners Club
Join Date: Aug 2005
Location: Nashua, NH
Posts: 878
|
Here's an earlier posting that you might want to check out: Fixed Vectra Entry Door Rattle
__________________
Chris Beierl
2005 Winnebago Vectra 36RD
|
|
|
|
| |
|
08-16-2010, 08:49 PM
|
#10
|
|
Senior Member
Monaco Owners Club
Join Date: Oct 2009
Posts: 134
|
I spray the latch on the door with PAM cooking oil before each trip. Stops the squeaking and smells nice and buttery when entering the coach.
Chris
__________________
Monaco Dynasty
|
|
|
|
| |
|
08-17-2010, 10:46 AM
|
#11
|
|
Senior Member
Mid Atlantic Campers
Join Date: Oct 2007
Location: Allentown, PA
Posts: 367
|
Hi CB:
Thanks for the link, that was very interesting. I have to check those rivets. I knew you guys would have some kind of an answer.
Regards... Jim P.
__________________
Meridian 2004 36G DP
2010 Jeep Sahara Unlimited
Two HD's for company
|
|
|
|
| |
|
 |
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
|
| Thread Tools |
Search this Thread |
|
|
|
| Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|

»
Recent Discussions

»
Upcoming Rallies
No events scheduled in the next 365 days.
|
»
iRV2 on facebook
|