ON the motor there is a shaft, it SHOULD always stop in the same position, If you re-index the odds are good the wipers will wipe DOWN onto the front of the vehicle not UP.
Now. depending on the wipers.. As I recall on the "Back" of the wiper shaft is a bell crank type lever, the arm from the motor pushes and pulls on this device to turn the shaft and operate the wipers.
Take a look at it, if the wipers are stopping OUT instead of IN, it may be that you need to remove the shaft, Rotate it about 180 degrees so the crank is opposite of what it is now (IE: If it's on top, put it on the bottom) then re-index the wipers. That should work.
__________________
Home is where I park it!
|