I don't know if this will help you or not but this is the way the fobs are
re-programed on a 97 Ford F250HD.
Read first and then look for the
module and the program connector.
You have to have all of your fobs present as when you enter the programming
mode, it will erase all from memory.
You are also going to have to locate the module (remote entry receiver
module) I referred to above and the program connector. The remote entry
receiver module is located in the LH side of the lower instrument panel to
the right of the steering column, just above the driver's right foot area.
Read this in total and then see if it will work for you.
NOTE: The remote entry receiver module erases all previous transmitters from
memory when the transmitters are programmed or reprogrammed. The remote
entry receiver module can store up to four transmitters in memory.
To program (or reprogram) transmitter(s) into the remote entry receiver
module, perform the following steps:
Turn key to the ON or ON/ACCESSORY position and momentarily short the two
terminals of the program connector (C4) (a two-pin connector taped to the
wire assembly connected to the remote entry receiver module, approximately 6
inches from the remote entry receiver module). All doors should lock then
unlock. Remove shorting pin.
Press any button on transmitter. All doors should lock then unlock to verify
that the transmitter has been programmed. If door locks do not respond,
press button again (up to three times maximum with the same transmitter).
Repeat Step 2 to program additional transmitters into the remote entry
receiver module (up to four transmitters maximum).
Key off. All doors should lock then unlock.
Check operation.
__________________
Dave and Karen -- '02 Ultimate Advantage 36 C, 350 HP Cummins, Allison 3060 Tranny, 2013 Ford Edge, InvisiBrake
|