08 ksdp 3910

[rlott2k]

I'm baaack! Yet another question for my fellow forum watchers.
My rear splash guard sit just an inch or so off the ground while driving, air bags full. It scrapes when backing up over any speed bumps etc. Recently while auto levelling, air bags dumped, and I'm guessing, the rear end sat on the splash guard and threw the whole procedure out of sack. Rear level legs didn't contact the ground . I've taken to bunjee cording the thing to the hitch so is not in the way. Any one else seen this? I'm going to get my ride height checked. Its a full width thick rubber with Newmar in stainless riveted to it. I imagine its o.e.

[CoachC]

Originally Posted by rlott2k

I'm baaack! Yet another question for my fellow forum watchers.
My rear splash guard sit just an inch or so off the ground while driving, air bags full. It scrapes when backing up over any speed bumps etc. Recently while auto levelling, air bags dumped, and I'm guessing, the rear end sat on the splash guard and threw the whole procedure out of sack. Rear level legs didn't contact the ground . I've taken to bunjee cording the thing to the hitch so is not in the way. Any one else seen this? I'm going to get my ride height checked. Its a full width thick rubber with Newmar in stainless riveted to it. I imagine its o.e.

I do the same bungee trick on my '05. I think it is hung on chains so may be able to be raised a little. Quite a few remove that hanging guard and claim the toad does not get as dirty when removed. I can't verify that.
Best of luck and safe travels!

Cheers