Generator Quest. #2

[mercerc44]

Earlier asked about cut off during trip. Got home filled fuel up got out manual and attempted to read code. No blinking light. (I assume it is the light on the start/stop switch) Also, gen will prime but will not turn over. Rig going in for service next week, what should we look for??

[mercerc44]

Earlier asked about cut off during trip. Got home filled fuel up got out manual and attempted to read code. No blinking light. (I assume it is the light on the start/stop switch) Also, gen will prime but will not turn over. Rig going in for service next week, what should we look for??

[bontemp]

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">R </div></BLOCKQUOTE>
You'll need to read the code at the time the genset shuts down, then hit the stop button to get the more definitive code - mine gave three flashes, I hit stop and got three fashes, followed by six flashes i.e. a "36" fault code

[afrank1971]

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">DancinCampers wrote:
You should be able to display the last fault code by pressing the stop button 3 times within 5 seconds. I'm not sure if this is true for all Onan gens, if not your manual should tell you how. </div></BLOCKQUOTE>

This may help to see what your last fault code was, if it is still stored / hasn't been reset. Good luck.