My switch is in the door about six inches from the bottom on the latch side of door. I need to replace the switch with new. How is the switch held in place? I can see no screws etc holding it to the door frame and access to see it is very poor.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Nor'easters Club Workhorse Chassis Owner iRV2 No Limits Club
Join Date: Oct 2004
Posts: 30,785
Is this the switch for steps may just be inserted in cut out hole. pry the tabs with a thin flat screwdriver.
The wire leads for switch if steps go to the chassis frame under steps area and is one of the grounds that needs to most cleaning.
Is this the switch for steps may just be inserted in cut out hole. pry the tabs with a thin flat screwdriver.
The wire leads for switch if steps go to the chassis frame under steps area and is one of the grounds that needs to most cleaning.
On my door frame there is a black round (?) part that looks just like the magnet part that is installed in the door. Does it pry out? It is impossible to get to from the back side of door frame. When the steps don't deploy a simple tap on the switch makes it work. Sooner or later I know this will stop working.
Revolution LE 38X C9 Cat
Linear Mode
