|
|
04-09-2017, 09:38 AM
|
#1
|
Senior Member
Newmar Owners Club Freightliner Owners Club
Join Date: Oct 2015
Location: Where jacks land
Posts: 225
|
LED Strip on top of passenger side slide
Has anyone put a LED strip for patio lighting on the top their slide for patio lighting? If so where did you get your power source from? Where do you mount the IR controller sensor?
On my Ventana the slide is the living room/kitchen slide and would like to put a LED strip at the top of the slide just below the slide topper cover.
The only lights I have now are the security and door light that get pretty much blocked when the slide is out.
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
04-09-2017, 10:08 AM
|
#2
|
Senior Member
Newmar Owners Club Freightliner Owners Club iRV2 No Limits Club
Join Date: Nov 2016
Location: Tucson, Arizona
Posts: 1,580
|
I've been considering doing the same thing. On my coach this would be on the Kitchen/living room slide out. The slide out has cabinets on the ceiling. I am thinking I will power it by tapping into the overhead puck lights in those cabinets.
I think I am just going to put a switch in the cabinet nearest the door and forget purchasing a kit with the IR sensor entirely. This will also make the purchase cheaper by allowing me to get a roll of LED lighting.
White lights is what I want anyway so I will use the left over LED strip lights to convert some of my florescent coach ceiling fixtures.
__________________
Our Blog - Wandering Toes
Our Coach - 2005 Newmar Northern Star | 350 Cat C7 3126 | Freightliner XC Chassis
2018 Jeep Renegade Trailhawk
|
|
|
04-09-2017, 10:43 AM
|
#3
|
Member
Join Date: Aug 2015
Location: Seal Beach, California
Posts: 65
|
I pulled power for an LED strip under the kitchen slide from the outside TV cabinet.
Works well for lighting the "patio" area in dark campsites
|
|
|
04-09-2017, 11:27 AM
|
#4
|
Senior Member
Newmar Owners Club Freightliner Owners Club iRV2 No Limits Club
Join Date: Nov 2016
Location: Tucson, Arizona
Posts: 1,580
|
Quote:
Originally Posted by Beach Aire
I pulled power for an LED strip under the kitchen slide from the outside TV cabinet.
Works well for lighting the "patio" area in dark campsites
|
That really looks good.
__________________
Our Blog - Wandering Toes
Our Coach - 2005 Newmar Northern Star | 350 Cat C7 3126 | Freightliner XC Chassis
2018 Jeep Renegade Trailhawk
|
|
|
04-09-2017, 02:57 PM
|
#5
|
Senior Member
Newmar Owners Club Freightliner Owners Club
Join Date: Oct 2015
Location: Where jacks land
Posts: 225
|
Quote:
Originally Posted by Beach Aire
I pulled power for an LED strip under the kitchen slide from the outside TV cabinet.
Works well for lighting the "patio" area in dark campsites
|
Looks nice. Are the LED's in the awning or attached to the slide?
|
|
|
04-09-2017, 03:18 PM
|
#6
|
Senior Member
Join Date: Feb 2012
Location: Bella Vista, Arkansas
Posts: 5,389
|
On my previous Tiffin I installed some LED strip lights under my awning and connected the power to the scare-light. On the Ventana the scare-lights are not on the slide. I now need to figure out my options.
__________________
Raymond, Dee Dee and Sophie (Yorkie)
2023 Chevrolet 2500HD LT 4X4
2024 Grand Design Reflection 296RDTS
|
|
|
04-09-2017, 03:36 PM
|
#7
|
Senior Member
Newmar Owners Club Freightliner Owners Club
Join Date: Oct 2015
Location: Where jacks land
Posts: 225
|
Quote:
Originally Posted by reubenray
On my previous Tiffin I installed some LED strip lights under my awning and connected the power to the scare-light. On the Ventana the scare-lights are not on the slide. I now need to figure out my options.
|
They are the same place on mine, at the 1/2 bath and next to the front door
|
|
|
04-09-2017, 03:44 PM
|
#8
|
Senior Member
Newmar Owners Club
Join Date: Dec 2008
Location: Maggie Valley, NC
Posts: 903
|
Following.....
|
|
|
04-09-2017, 04:03 PM
|
#9
|
Registered User
Winnebago Owners Club Vintage RV Owners Club
Join Date: Apr 2010
Location: Cherry Creek, BC Canada
Posts: 7,648
|
Sam Ting
|
|
|
04-09-2017, 04:28 PM
|
#10
|
Senior Member
Join Date: Feb 2013
Posts: 1,125
|
On our Bay Star, I attached the LED strip to the awning rail. I realized that where the rear awning arm was located was right over the bathroom (medicine cabinet). in a adjacent cabinet was one of the 12V fuse blocks. I got the power from there and instead of using an IR controller, I went with an RF controller. You do not have to have line of sight for it to work.
__________________
Bill & Denise
2014 Bay Star 3103 - 5 Star Tune, CHF, Magne Shade
2017 Jeep Wrangler Unlimited Sahara
|
|
|
04-09-2017, 07:59 PM
|
#11
|
Senior Member
Newmar Owners Club Freightliner Owners Club
Join Date: Feb 2016
Location: Mississippi
Posts: 607
|
Installed an LED strip light on the front passenger slide on the topper cover. I ran the power cord down behind the edge of the slid then across the bottom into the back storage compartment. I started to tie into the basement lights but changed my mind as would have to turn on basement lights in-order to use strip lights. I ran a new wire from the battery compartment over to where I put the switch inside the storage bay. I mounted the switch just inside on the side wall. Easy access even with the slide out
__________________
2016 Newmar Ventana 4002
2020 Jeep Gladiator
|
|
|
04-10-2017, 04:50 AM
|
#12
|
Senior Member
Newmar Owners Club Ford Super Duty Owner
Join Date: Oct 2014
Posts: 1,724
|
Quote:
Originally Posted by Beach Aire
I pulled power for an LED strip under the kitchen slide from the outside TV cabinet.
Works well for lighting the "patio" area in dark campsites
|
On our Canyon Star, all we have is the porch light, not even a scare light!!
I thought of, looked at, at almost did the LED strip in the awning.......
Problem being the awning is high off the ground, cannot be reached without a ladder - then there is the wind. IMHO, the awning is poor and the slightest breeze has it jumping up and down and I retract it........
I spoke, thru emails, to my friends up at Newmar (3 hours from my house) and they will be installing LED strips under my kitchen slide. Above pix looks great and is just what I an looking for.
Wish I was handy - but I am not.........
It gets installed early May.........if I remember, I'll post some pix - don't be afraid to remind me if you'd like.........LOL
g
__________________
Glenn & Angie - my Guardian Angel plus "Haddington & Sophie The Airedales".
2017 Newmar Canyon Star 40', FMCA - Retired Army Sergeant Major
|
|
|
04-10-2017, 06:37 AM
|
#13
|
Senior Member
Join Date: Mar 2009
Location: Apollo Beach & Key West , FL
Posts: 3,837
|
I suggest you get LED's with an RF controller. You can mount it anywhere as you do not need line of sight. Just look at Amazon or Ebay for RF controller in your search
__________________
2013 DS 4338
2015 F-150 toad with kayaks,bicycles and a Harley in the back
new toad 2023 Sprinter with all the toys inside
|
|
|
04-11-2017, 10:15 AM
|
#14
|
Senior Member
Newmar Owners Club Freightliner Owners Club
Join Date: Jul 2014
Posts: 142
|
Quote:
Originally Posted by stang37
Installed an LED strip light on the front passenger slide on the topper cover. I ran the power cord down behind the edge of the slid then across the bottom into the back storage compartment. I started to tie into the basement lights but changed my mind as would have to turn on basement lights in-order to use strip lights. I ran a new wire from the battery compartment over to where I put the switch inside the storage bay. I mounted the switch just inside on the side wall. Easy access even with the slide out
|
Stang can you take a couple of pictures? I plan on doing the same thing. I was thinking of drilling in to get power from the cabinet inside where the microwave is but I don't like drilling into the new MH yet.
__________________
Nick and Sue
2017 Newmar Ventana 3709 All Electric
2012 Jeep Wrangler Sport
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|