New Aire 30amp Hook Up

[timekeeper]

Question: Is there anything special that needs to be done with Silverleaf or any other setting that needs to be reset when I hook up my NA to a 30amp post?
I have been doing this with my previous MH for over a decade and understand about what can and can’t be used once hook up takes place but don’t know if some setting needs attention first if I do it in the New Aire.
Thanks...

[WardSimmons]

I read a previous New Aire post a couple of months ago (not sure where) that said between 50 amp and 30 amp, the SilverLeaf system recognizes input and adjusts accordingly. There is a selection in a SilverLeaf submenu, but manual adjustment is not required. According to this post, manual adjustment would be required for 20 amps, but I don’t intend to hook up to that.

I used a 30 amp hookup once and paid attention to what I ran so as not to draw too much. When unplugging I was surprised how hot the dog bone was (not good). I’m not sure why it happened, but if you use 30 amp, monitor the temperature of your dog bone.

[BuckyII]

Originally Posted by timekeeper

Question: Is there anything special that needs to be done with Silverleaf or any other setting that needs to be reset when I hook up my NA to a 30amp post?
I have been doing this with my previous MH for over a decade and understand about what can and can’t be used once hook up takes place but don’t know if some setting needs attention first if I do it in the New Aire.
Thanks...

When in storage, I’m plugged into 30 amp. No special settings that I’m aware of. However, I’m very careful to have only one a/c active and the oasis off....mostly to avoid tripping breaker at shore power source.

[Aegon]

I’ve used a 30A service several times, no adjustment necessary in SilverLeaf.

I’ve not experienced the hot dog bone Ward described; however, I’ll be paying better attention in the future.