On our new Bay Star 3532, I am trying to get signal from the RV park cable to my TV. I have cable plugged in but don’t seem to be able to get it to work. OTA tv and satellite inputs on tv are working fine but can’t find how to switch to cable. Any help out there?
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
The Campground cable is connected to the input in the storage bay...
The OTA antenna booster is turned OFF. If left on, it is switched to the OTA antenna...and cable will not pass thru. On ours it is a very tiny button on the face of the Winegard panel. If the booster is ON, a little green LED is visible. When OFF the LED turns off too. This panel is on the sidewall close to the floor behind the copilots (Passenger) seat.
On the tv...you have the input set to TV.
In the TV setup menu for channels, you switch the input from antenna to cable.
Then on the next line, you scan for channels.
The tv tells you it could take up to 30minutes...when done scanning...you're all set.
__________________
Charlie & Ronni
2016 Ventana 4037
On a bath wing antenna, the amplifier is located in the center section of the antenna. The wall-plate is only a switch with power to the antenna or not,for cable,no 12Volt power is needed
Siggy
Linear Mode
