security lights

[Keith727]

Help/// The security light on curb side burned out. the security light on road side was out aslo. Replaced the bulb on curb side it works ok, but the bulb was good on road side. Checked for voltage and was zero. Is there a seperate fuse for each light? Thanks/////
2005 Dutch Star 3815

[tom chelbana]

There is only one fuse for both security lights. Might check to see if there is power to the light it's self. Pull light off and then check voltage on both power and ground. Tom

[GaryKD]

Hi Knot-Fly'n,
Like Tom posted, there is only one fuse for both lights. Maybe the socket is corroded or a wire has fallen off. If the ground wire is good, finding where the power is being lost will be a challenge. Consider calling Newmar customer service at 800-731-8300.

[bonzocfi]

One fuse but two switches.

[Mr_D]

We have four lights and four switches in ours and I don't know about the fuses as I've never had to find/replace them.

[Keith727]

Help///// where is security light switch on drivers side???? Thanks/

[Steve N Sal]

Mine is in the panel above the entry door.

[calhyatt]

Originally Posted by Knot-Fly'n

Help///// where is security light switch on drivers side???? Thanks/

Mine is on the forward wall of the living room slide out.

[dennis45]

Originally Posted by Steve N Sal

Mine is in the panel above the entry door.

X2, above the entry door

["007"]

Originally Posted by calhyatt

Mine is on the forward wall of the living room slide out.

x2 with two other switch's for under cabinet lights and scorn lights either side of couch.
There is one also in bedroom slide wall for driver side over the water closet below on bedroom slide outside wall.

[calhyatt]

Originally Posted by "007"

x2 with two other switch's for under cabinet lights and scorn lights either side of couch.
There is one also in bedroom slide wall for driver side over the water closet below on bedroom slide outside wall.

Same switch locations in my KSDP.

[EDALLSAILS]

I replaced both lights with the motion activated type and rewired the switch so it is always in the ON position. When it gets dark the lights automatically are in the watch mode. when movement detected they turn on where the motion was detected. Thinking about installing another one on the front and rear of MH for safety. They would be wired with a switch so they don't activate while driving. safe travels... ed

[Keith727]

Thanks guys, found the switch and replaced the bulbs with LED bulbs. Thanks again, Keith (Knot-fly'n///////