Slide not fully closing

[buddy110]

Hi guys and gals.
I need sone techincal help. Today as I prepared to leave a campsite my door side slide would not seat closed all the way. The bottom is about 1.5" from seating and the top about .5" . The rear of the slide is a little tighter but still out farther than the bottom.
I reopened it and when I tried to close it again it would not move. There was plenty of battery juice available. It moved in slightly then stopped. Finally got it closed but not fully as I stated above.

Any ideas?
2015 canyonstar 3914

["007"]

Your batteries may be to low to get your 12v high torque motor to operate.
You need to plug into a shore line source or run your Gen for a good clean 12v's.
In QT's 1 & 2 there are links in slide section for more information on your slide systems.
All the links below in my signature will help you with your Newmar problems.
Enjoy and safe travels.

[buddy110]

Originally Posted by 007";3221785]Your batteries may be to low to get your 12v high torque motor to operate.
You need to plug into a shore line source or run your Gen for a good clean 12v's.
In [B][URL="http://www.irv2.com/forums/f103/original-part-1-and-2-quick-tips-and-easy-mods-18509.html

QT's 1 & 2[/URL][/B] there are links in slide section for more information on your slide systems.
All the links below in my signature will help you with your Newmar problems.
Enjoy and safe travels.

Thanks, I will check those out.
The batteries are fine, it was/is plugged in. It's not an electrical problem, it's mechanical.