Wiper blade problem

[TXredfish]

On my wiper blade, is the water-cleaner output which has a cap at the end of the water output tube. This cap keeps coming off and the water does not go where it was intended. Do you think, a light application of silicon will hold this cap on or is there a better way. I really don't want to glue on with epoxy etc, in case I need to remove the cap. Thanks .............

[Baby Bear]

Had the same problem. The only way I was able to keep it connected was a small dab of super glue. Make sure the glue almost dry on both surfaces, that way you have a chance of not getting it in the water hole.

[tmitchell]

Mine broke off a few years ago. I super glued it back in place. No problem since then.
Tom