Wiper Blades 31"

[Richardrky]

Let me try this again. I have a 2004 Newmar Kountry Star 3740 on a 2003 Workhorse chassis and I need new wiper blades. Mine measures 31", not 32" as the PPL site (RV parts) says that a 2004 Kountry Star uses. Which is really the correct size and where can I buy wiper blades this size? I tried NAPA, Autozone, O'Reilly, and Walmart to no avail.
Thanks

[KSDP]

I bought 28" at Wal-Mart and drilled out the hole tfit the bolt. Sure was a lot cheaper than the dealer and after haven't even noticed the difference in length.

[Floridakamper]

I also use the 28's and don't notice the difference either.

[Richardrky]

Thanks for the replies. For the 28" blades, did you buy a specific brand and/or type at Walmart?

[Floridakamper]

I didn't. As mentioned I had to drill the hole in the wiper a little larger.

[siggyd]

I bought "RAIN-X weatherbeater" 28", drilled the center hole to 0.2" or 5 mm, works for me. Less then $ 10 a blade.
05 KSDP,Cat 330
Siggy

[Richardrky]

I bought a 28" Michelin wiper blade at Walmart for $7.97. I had no problem drilling out the rivet and enlarging the holes for the bolt sleeve. I compared the "cheap" blade to the expensive 31" blade that was orginally installed by Newmar and I tell you the "cheap" blade looks at least as strong. For $8 I thought I would try it on the passenger side and see how it works.

[RUFINIT]

Same here. Bought 28". Newmar wanted over $50 each for the 31'. Cannot tell the difference.