2002 38 ft alpine coach hydraulic motor

[bosboy58]

I need to replace the hydraulic motor but cannot find instructions on how to remove. can anyone tell me where to find this information. thank you.

[Dave Fernandez]

Hello & Welcome to IRV2 and the Alpine Coach Forum:

I am assuming that you are taking about the HWH Pump motor. To replace the HWH motor first disconnect all of the batteries and electrical power to prevent any problems.

Remove the solenoid and you will see two small bolt heads on the end to the motor. Loosen them from the manifold and remove the motor and reverse the procedure and reconnect the batteries and test.

[EngineerMike]

I assumed we were talking about the hydraulic fan motor for the radiator. Silly me.

Dittos on finding your way to all good technical info on Alpine Coaches, here on iRV2!! Hope to see you around.

[bosboy58]

Thank you for the information. I am still trying to figure out how to use this site.

[EngineerMike]

Bos- one quick tip is click on UserCP at upper left, edit your profile. Put your coach info into a "signature" so you don't have to repeat that each post. Anyone reading can then relater your questions & answers to your model year experience. Lots of Alpiner's know of the differences between model years, so that's a big help in getting good info spread around.

[FRED MASINO]

You might want to check the negative ground on the brush for the HWH pump motor, its riveted to the end plate of the case. I drilled the rivet out and replaced it with a bolt. Fixed my pump motor