Acrylic Grab Bar

[Jeff and Cheryl]

The Grab Bar to the left of the entrance door busted in half. It is a pretty clean break. Does anyone have ideas about who fabricated these for WRV, or a part number and manufacturer or ideas as to if a glue would hold the parts together and if so what glue, or any ideas as to where to go to get a replacement made?

I was going to install an aftermarket bar, but when I went to remopve the old one, discovered that it is a bar that fits into a fixture. The upper part of the fixture has a small lightbulb in it. Turn on the switch, light shines down through the clear acrylic.

Any ideas would be greatly appreciated.

[Jeff and Cheryl]

The Grab Bar to the left of the entrance door busted in half. It is a pretty clean break. Does anyone have ideas about who fabricated these for WRV, or a part number and manufacturer or ideas as to if a glue would hold the parts together and if so what glue, or any ideas as to where to go to get a replacement made?

I was going to install an aftermarket bar, but when I went to remopve the old one, discovered that it is a bar that fits into a fixture. The upper part of the fixture has a small lightbulb in it. Turn on the switch, light shines down through the clear acrylic.

Any ideas would be greatly appreciated.

[MonacoMama]

you can check here...or do a search on iRV2. A few Monaco folks have done their own and made the solid ones into lighted handles...
Good Luck

MM

[Jim Bragg]

Jeff check www.rvsurplussalvage.com look under hardware they have the handle for 20.00.

[Jeff and Cheryl]

Jim,

Thank-you. You hit the nail on the head. IRV2 ROCKS.