2002 Dolphin 5342 Bed Room Slide won't extend

[wmaier]

I can not extend the bedroom slide using the panel switch. After extending it manually I can retract it using the panel control. I'm looking for others that may have had similar issues and find out what you discovered.

[hogrider80]

In my case it was the opposite problem. Would extend, but not retract. I figured it was a weak relay on the control board, but they're soldered in. Replaced the control board (it's in the front basement compartment on the passenger side), and all was well. I got the board through the dealer, but I'll bet it could be found by googling the part number.

[Richard S.]

To test your system ,you can switch the main and bed room plugs on the circuit board in the 12 volt center. If you need to replace the board I found this place.

http://www.rvparts.com/product-127-119553

[wmaier]

Thanks for your past experiences. I will explore the swap the connectors on my next trip to visit my MH. I don't keep it close to my home. I also purchased both ckt boards found in the forward compartment to have if needed. The motor is okay since I can make it run in both directions. Probably the relay. I'll update once I reslove the problem.

[wmaier]

Bedroom slide problem fixed by replacing the relay circuit board. The existing wiring harness to both the BCC and slide board had very little slack even after cutting the tie wraps. New board layout not same as old board but close enough to get the job done.

[Richard S.]

Good deal, glad it is working out for you.