Can't remove drawers under dining booth

[kerrbe]

I have a 1998 SeaView and I am trying to pull the drawers under the booth dinette out so I can repair a broken door front. They glide out but I cant seem to remove them. Any ideas on how to get them off the track?

[Richard S.]

Link attached. removing a drawer

[TandW]

With drawer at natural full open position, lift gently and pull out further to remove. If this does not work, look for small riveted flat springs that may be locking slides together. Look for a toggle device that may be swung out of the way with a finger. Finally, it may be that a screw has worked out of its hole and is stopping removal. Good luck!!

[Vegasdan]

I sent you a PM.

[bldrbob]

If it is like my dinette the bottom of the draw can be pushed up exposing the screws holding the track. I don't think the slides come apart.
BOB

[DarrylGF]

I had a hard time getting my bench drawers out too but it is pretty simple once you know how. Take the cushions off the bench. Remove the screws holding the bench seat and lift the seat boards. Reach into the drawer and pull the fabric material lining the drawer and it should lift right out. Then you can get at the screws holding the runners to the bottom. There are stops on the slide rails so you can't pull them all the way out and you can't get to the side screws other than the way I did it. Give it a try.
DarrylGF 99 Tradewinds 7370