Community Forums

Gdlow · 10-01-2018, 12:22 PM

Here is the issue. My wife and her finely tuned eyesight swears the slid when “closed” is not fitting square. Took it to MH dealer! They said it is fine, and charged me $140 for that. It kinda does look a little off!
Thoughts on how to do my own check.

Gerryl · 10-11-2018, 01:26 PM

Mine is off also.

Found your post when searching for some help.

BOOZE TRAVEL · 10-12-2018, 11:44 AM

If it is a Power Gear setup like my Tradewinds, just put a 2x across the bottom of the slide with it about 1/2 way out. There are a couple of bolts that connect the slide to the bars. Loosen them and jack the slide to where you want it with a floor jack, then tighten the bolts back up. Took me about 10 min.

Kasey · 10-18-2018, 07:54 AM

I have a 04 Dolphin 5342. Living-room slide is low on the on the forward corner and ripping the seal out when extended. It does not have the vertical adjustment bolts shown in the power gear manual only the large horizontal bolts that hold it to the rails. These bolts have been adjusted as far as the thick steel washers will allow. Has anyone had to cut these washers down to adjust the slide or do I have other issues? Thanks