Slide out seal material

[KentM]

I need to replace the seal under the lounge slide. Does anyone know of a place that might supply that material. I doubt that I can get any information as to the part number used by National RV. This material is the classic "P" shape with the long flat side that is glued down. This long side is approx 2" and the height of the "P" part is about 3/4" inch high and is made of two chambers. Any and all ideas appreciated.

[KentM]

I need to replace the seal under the lounge slide. Does anyone know of a place that might supply that material. I doubt that I can get any information as to the part number used by National RV. This material is the classic "P" shape with the long flat side that is glued down. This long side is approx 2" and the height of the "P" part is about 3/4" inch high and is made of two chambers. Any and all ideas appreciated.

[06 Tradewinds]

You might take a look at the site found at the following link.

http://www.uni-grip.com/index.htm

Good luck and safe travels.

[KentM]

Larry,
Thanks for the info. That is exactly what I was looking for and I have downloaded the catalog and sent them an email for information on a couple of their products.
Best regards
Kent

[pappaono]

Kent; I was having the same problem and found some seal material that would work at Camping World. It only has one chamer, but everything else matched up prefectly. The invoice is out in the car, but if you need the information, let me know and I will find it.

[Richard S.]

pappaono,
If you have the information on this seal material it might be good to post it so it will be saved.

[pappaono]

The seal material I was able to get from camping world is call P rubber molding box , the part number is I17f7. Hope this helps anyone that needs the slide seals. It would also help if you could take a piece of the old material with you.

Have a safe and enjoyable Holiday weekend

Rich

[sergeant mike]

re attach seal with double sided auto tape