Community Forums

jeepfreak · 06-07-2016, 07:41 AM

Have a 07 34wa open road and lost power to the charge line in the rear plug which is needed to operate the lights on the toad. Does anyone know where the fuse is located?

JMynes · 06-07-2016, 09:18 AM

Quote:

Originally Posted by jeepfreak

Have a 07 34wa open road and lost power to the charge line in the rear plug which is needed to operate the lights on the toad. Does anyone know where the fuse is located?

Not sure if this helps, but mine is only hot with the key on.

**CLIFFTALL** · 06-07-2016, 09:22 AM

I see you have a WH chassis. The fuse in my Ford was under the hood with the Ford fuses.

jeepfreak · 06-07-2016, 09:46 AM

I am aware the key has to be on. Did check the fuses under the hood, all were good and had nothing labeled for it. Thanks for the replies.

**CLIFFTALL** · 06-07-2016, 09:52 AM

Your chassis manual ( if you have one ) , should point you to the fuse. Some fuses look good but they're not.

jeepfreak · 06-07-2016, 10:43 AM

All the fuses I checked with a 12v test light. Don't have a chassis manual but have the tiffin wiring manual and it has no termination for the trailer plug and it's pretty much a waste of paper

jeepfreak · 06-07-2016, 12:51 PM

Found it! It's in the forward storage compartment with solenoids and resettable 12 volt circuit breakers. Third one down on the right side , and it's marked , are you ready , "30amp speed a/c / ignition breaker". It only has one wire in and one wire out. It was the only fuse/circuit breaker that had power in but not out. The button would not reset. Put alligator clip across the two terminals and walla power to the charge wire. Now I have to find another breaker that I can mount in that spot. Tiffin must have had some extra labels kicking around and decided to put one under this breaker.