Bounder: Dream Dinette

[leesdx1]

Hello all, Question, if anybody installed the Dream Dinette from Cass Hudson Co. in a Bounder that has the utility hump, see pix. What is the workaround for this issue or can it still be installed?

Thx, Dale
96 Bounder

[BFlinn181]

I don't see any pictures, except for the ones at Cass Hudson Co. Where is your 'utility hump'? The dinette photos don't really give dimensions of the seat bases or really any dimensions at all. You'll need to measure your space very carefully, including the 'utility hump' and then contact the company to see if their product will fit your space.

[leesdx1]

Originally Posted by BFlinn181

I don't see any pictures, except for the ones at Cass Hudson Co. Where is your 'utility hump'? The dinette photos don't really give dimensions of the seat bases or really any dimensions at all. You'll need to measure your space very carefully, including the 'utility hump' and then contact the company to see if their product will fit your space.

Sorry BFlinn181, I did contact the company and she asked alot of questions for fitment and i even sent pixs. It was just one of those things that wasn't ask or notice. I think I figured out a way, but the table will sit 1" higher, else I have to re-route all the utilities to the left under the bench. I'm going with the 1" higher ideal cause I hate to cut the 2 soft cooper propane lines

[leesdx1]

Originally Posted by leesdx1

Sorry BFlinn181, I did contact the company and she asked alot of questions for fitment and i even sent pixs. It was just one of those things that wasn't ask or notice. I think I figured out a way, but the table will sit 1" higher, else I have to re-route all the utilities to the left under the bench. I'm going with the 1" higher ideal cause I hate to cut the 2 soft cooper propane lines

pix #1

[leesdx1]

Originally Posted by leesdx1

pix #1

pix #2