front of sllde drags

wdcrowder · 10-24-2011, 01:15 PM

I have 2007 Gulfstream independance the front slide for the dining room drags on the floor when extending and closing the slideout. I have powergear electric above floor slides there does not apear to be height adjustment on these slides. There is 1/2 screw with a lock nut on both the drive and idler slides these are both loose but it does not appear that they will effect height adustment does anny one know what these two screws do and how to adjust them. also does anny one know how to stop the slide out from draging on the floor

Thank You
Wayne

**"007"** · 10-25-2011, 01:12 PM

Wayne welcome to irv2.
No answers so far I'm going to move you post to Gulf Stream forum maybe we will have better luck there.
Not sure this answers your question but do you have rollers for slide to track on over rug or is there a slide on bootom of slide floor to guide over rug. If either one of these are loose or misplaced will give you a problem.
I'm sure someone will help you.

Luckiest Dre · 10-25-2011, 06:33 PM

I went to power Gears web site was was able to download directions for adjusting the different slides.

Luckiest Dre · 10-25-2011, 06:39 PM

http://support.powergearus.com/techd...ideout_Sys.pdf

wdcrowder · 10-26-2011, 08:48 AM

Thanks for the information but my slides are electric. I have looked at all of the information on the powegear web site but it has been no help. I sent a message to gulfstreem but the awnser was no help they said look for a up and down adjustment which there does not seem to be nor did they tell me what the two 3" inch screws that are on the end of the slides and are loose are supposed to do.
thanks
Wayne