When moving the switch to "out", it energizes but no outward movement. Hitting the "in" makes loud metallic sounds but of course it has nowhere to go since it's still in the travel location. It worked a month ago before we moved into this resort a month ago. The gen starts and runs but isn't putting out power so I probably need to hit a reset button.
Doug Nelson
'05 Allure 430 Hood River #31125 Cat C-9
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
I am assuming that yours moves in and out with a hydraulic ram? Or is it an electric gear motor?
When I hit the extend button, the hydraulic ram pushes out the sliding tray but there is a locking mechanism on the passenger side that has to release. It is a safety feature that keeps the gen slide from sliding out without power. That safety latch is just a catch that flips up when the hydraulics pushes hard enough. If it is rusty or corroded or resists to much then the hydraulic pressure won't overcome it, it won't release and the slide wont budge.
I would look there first.
If you are not getting hydraulic pressure or can't hear the pump working as it builds up pressure, then you have an electric issue with no power going to the hydraulic pump.
If it is anything like mine, takes two people. 1 to flip the switch and the other to bump the drawer inward which helps release the switch. Then easy slide out.
__________________
------------------------------------------
"Mrs. CC. Magna" 36' 1993 Country Coach, Magna, 300hp Cummins, 5 speed Alison trans, #5016
127,000 miles and counting...
Sounds like your latch is working to well. Look at it carefully, it may have a 90 degree hook and you could grind it back down to a 75 degree angle so it releases easier. Also put a little grease or silicone spray on it to slip off easier.
The hydraulic cylinder can only push forward with so much pressure, which should be enough to kick the release up. If is does not release it means the latch is to tight, to rusted or with to sharp of a angle.
Linear Mode
