Go Back   iRV2 Forums > THE OWNER'S CORNER FORUMS > Country Coach Owners Forum
Join iRV2 Today

Mission Statement: Supporting thoughtful exchange of knowledge, values and experience among RV enthusiasts.
Thread Tools Search this Thread Display Modes
Old 04-28-2012, 06:07 PM   #1
Junior Member
Join Date: Apr 2012
Posts: 6
trailer brake wiring on 2005 Allure 470

Hi, I'm new to this forum and I hope someone can help me out. I just purchased a 2005 Allure 470 and need to put a trailer brake controller in it. Does anyone know if there are wires located somewhere up front for the controller that are already run to the back? I found wires in the back of the motorhome but not having any luck up by the dash. Also, are there any 110 volt receptacles outside, that I can plug a cord into for power off the generator to my trailer?
Thanks for any help

tom5731 is offline   Reply With Quote
Join the #1 RV Forum Today - It's Totally Free!

iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!

You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!

Old 04-28-2012, 06:55 PM   #2
Senior Member
dons2346's Avatar
Country Coach Owners Club
Join Date: Dec 2010
Posts: 3,655
Th9se extra wires are not under the dash. You will find them in the exterior compartment under the driver

dons2346 is offline   Reply With Quote
Old 04-28-2012, 09:39 PM   #3
Junior Member
Join Date: Apr 2012
Posts: 6
Thanks, I'll check tomorrow
tom5731 is offline   Reply With Quote
Old 06-15-2012, 11:16 AM   #4
Startech's Avatar
Solo Rvers Club
Join Date: Jun 2012
Location: Scouting for fun
Posts: 76
I have an 2004 Inspire and paid $20 to CC to be told that there was not a wire for the brake controller. Yours might be different. I ended up running a new wire from the dash to the tail. Not fun as there is no access to wires already running back there. So I had to drill a hole thru the floor under the dash (double walled) and run the wire entirely under the coach along the frame carefully avoiding all moving parts. There were a few wire ties existing under the front, but then hot glued the wire every 6 inches along the frame.

In my case, I disregarded the tail light brake wire on the rear connector and that is where I put the trailer brake controller wire as the right and left blinker wires also control the brake lights on the trailer. One of your controller wires needs to be attached to the brake light wire, which was under the dash.
Startech is offline   Reply With Quote

brake, wiring

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

» Virginia Campgrounds

Reviews provided by

Our Communities

Our communities encompass many different hobbies and interests, but each one is built on friendly, intelligent membership.

» More about our Communities

Automotive Communities

Our Automotive communities encompass many different makes and models. From U.S. domestics to European Saloons.

» More about our Automotive Communities

Marine Communities

Our Marine websites focus on Cruising and Sailing Vessels, including forums and the largest cruising Wiki project on the web today.

» More about our Marine Communities

Copyright 2002-2015 Social Knowledge, LLC All Rights Reserved.

All times are GMT -6. The time now is 01:21 AM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2016, vBulletin Solutions, Inc.