Tranny on scan gauge D?

[Lowflyer]

Needing to hear from ScanGauge users on similar engine and tranny models if transmission temps will appear on ScanGauge D if coach has a J1708 six pin connector? I've attached pix of the connector located at steering column. I believe it is a J1708 six-pin? (Correction welcome)
Tranny temp on analog gauge is reading 210F after 40 minute run. And has been that way since we bought coach in 2012. Want to get digital temp before doing anything more for cooling.
I understand differences between Silverleaf vs ScanGauge. Just needing quick & inexpensive diagnosis.
Thanks in advance.
Mike
'06 Inspire 360 #51534
Cat C-9
Allison 3000MH

[Mich F]

I just went to ScanGauge - Trip Computer + Digitial Gauges + ScanToolsand it looks to me like your trans. temp can be read with their scan gauge D with one of their X gauge functions on the gauge. They have a support section which should answer your question.

[deSanford]

Yes it can read the trans temperature. Just got our gauge back after sending it in for a software update. Pretty amazing little gadget. You can pick which gauges you want to monitor. Four at a time. deSanford

[Lowflyer]

Just to close the loop on this subject: I installed a ScanGauge D today and took the coach for a drive. The tranny temp on the factory installed analog dash gauge was reading 10-15 degrees warmer than the after-market scan gauge d. The results leave me with less concern for the tranny temp. Thanks to all for your input.
Mike