07 Camelot odometer - bad???

[studmuffin1]

Have a 2007 Camalot 42PDQ. The odometer, on the speedo gauge, now has all the elements lit up. I cann't get to odom 1, odom 2, or the trans temp readout. Just all the lines, on the odometer, are litup. Tried shutting all power off, for a while, no change, when the key is turned on, all the elements are displayed. Any ideas??? Can I unplug the wiring, behind the dash?? I can use the Aladin for mileage, it still works fine.

Help , the errant Muffin Man.

[ArmyEOD]

may check your run bay (front under driver) may be a dash fuse or relay you can pull and see if it will reset. Just an idea.

[Bob (WA0MQE)]

Have you called Monaco Tech Support yet? Their pretty good about helping out. I've called them on a couple of issues and they had the answers and what part/s to order to fix my problems.

If and when your problem corrected, please let us know what you found.

[studmuffin1]

Yep, Monaco tech support said "unplug the dash board plug, that should reset it". I found the plug, and all I did was wiggle it, couldn't get in to undo it. Now the dash odometer works. Oh well, next time I know the area to poke at.

Thanks, all. The Muffin Man.

[waco kid]

Where is the dashboard plug located?? .....Bruce

[studmuffin1]

Open up the top of the dash, straight down, behind the speedometer, is a 14/16 pin-sized plug. It plugs directly , from the rear, into the speedo housing. It is black, and has a slide lock on the top side. Just whiggled, and life has resumed.
The Electrifried Muffin Man.