50 amp but only 30 amp

[bridluz]

Originally Posted by bridluz

I do thank you for your post as I just returned from a trip and plugged the unit it and now I'm only showing 30 amps as well. So I'm not sure if it is the source or if my next trip will also display 30amps. I am tempted to just wait until my trip next month to confirm but then again at 30amps what might I not be able to use electronically while on that trip if I am stuck with 30 amps.

I had a breaker tripped. Simple solution. Stupid me.

[rdkng88]

Thanks to all !!!

[Dr4Film]

Okay, I have read this thread and believe you guys in what you stated about the Washer/Dryer circuit breaker HOWEVER my 2002 Windsor must be completely different than your 2001 Windsor.

I am currently hooked to a 50 amp pedestal with 50 amps showing as my source on the Intellitec EMS display unit in the bedroom. In fact I can read the voltage and amp draw of each leg on my Progressive Industries EMS display mounted adjacent to the Intellitec.

When I switch the Washer/Dryer circuit breaker OFF, my display does NOT switch to 30 amp. It stays on 50 amp as it should!

Are you guys absolutely SURE ???

I do know that there have been some really strange things that occur with the Intellitec EMS system so I would not doubt your findings.

But I'm just say'n.

Dr4Film ----- Richard

[rdkng88]

2002 Monico Windsor and the answer is absolutely