Cog belt for hydraulic pump

[flattop]

Posted this on the Cummins forum, found out the belt is a Monaco add on. Does anyone know where to purchase this belt other than Monaco. It is for a 95 Dynasty 8.3. Found some cog belts on Gates website but you need to know length, width, pitch (whatever that is) number of teeth etc. Hoping someone has had to replace one and had some numbers.

[walt2137]

This is a paste from Bill D on another forum. Hope I am not breaking any rules.

The "cog belt" is a Gates timing belt that is used to drive the
> > external Sunstrand hydraulic pump. They, Monaco, didn't go to direct
> > drive hydraulic pumps until the 96 models. The belt is about 1.5"
> > wide and 44" long and has gear type teeth. It is made of structural
> > nylon and kevlar.
That belt is very reliable. Just make sure
> > >that the tension is correct. Squeeze it in the middle from the top
> > >and bottom and there should be just one (1) inch of deflection
> > >total. Be sure to check the bolts on the hydraulic pump
> > >periodically and the pivot point bolt . They all can come loose and
> > >that is what eats the belt.
The old part # was 14MGT-1190-37

[flattop]

Walt, thanks for the belt number. Gives me something to start with.

[Jimmy F]

Quote:

Originally Posted by flattop Walt, thanks for the belt number. Gives me something to start with.

I need to get a belt for my 1995 Dynasty as well.... did that Gates number turn out to be the correct belt?

Thanks
Jimmy

[walt2137]

Jimmy I would bet that that is the right # as I posted above it was from Bill D and he knows the Monaco coaches and especially the older coaches. Those belts cost a few hundred bucks they are not cheap.

[Jimmy F]

Thanks Walt & Flattop I will be ordering mine this week.

Jimmy