Cruise won't release with the engine brake switch

[oldguy70]

My cruise control wouldn't release with the exhaust brake switch, so I had to hit the brakes or shut off the cruise switch to release cruise then my exhaust brake
would work. Monaco sent me the print that I needed a program to open it.
I used my 52 inch TV as the monitor an what I found was there was no wire
from the input on the exhaust relay to the input on the brake light relay.
Put the wire in an it works like a charm. These prints that you need a program
to open are awsome. They are colour coded and with the big screen I could
follow the wire with ease

[str8six]

Hello - could you post that file ?

My 2002 Windsor acts the same way.

Alan
02 Windsor PKD

[oldguy70]

There is no post. I fingered it out on my own. What I did was pull the clip off
the input post on the exhaust relay which is the clip opposite the white wire
and cut off the clip and put on a new clip (yellow clip) and put in an extra
wire which I ran over to the brake light relay and connected the wire with
the input on it. The brake lights coming on releases the cruise. The exhaust brake won't work unless the throttle is at idle position. I hope that helps.

[dunkirk]

That was a very good explanation of how your problem but my cruise control works intermittently and can not figure it out.

[str8six]

Hello - yes that does help. Your original post referred to a print that Monaco sent you - I was asking about that print.


\Alan