Community Forums

tomclayton1 · 12-03-2017, 07:03 PM

04 HR Ambassador. Leaving MN [19F] on trip to Phoenix driver's side lower convex mirror blew off two miles from home and is gone. I saw the thread on reattaching one, just wish I had one to stick back on. Anyone know where I might be able to buy a replacement? Source & part # would be a blessing. Don't see any Mfg data on the mirrors.
For what it's worth, I'll be using automotive double sided trim tape to put the replacement on when I find one.

vsheetz · 12-03-2017, 07:09 PM

If no name on the housing post a picture and someone will likely recognize it.

dennis45 · 12-03-2017, 07:23 PM

The mirror is likely either Velvac or Ramco. Do a google search and see if you can find a match.

http://www.ramco-eng.com/mirror-chart

https://www.velvac.com/products/mirrors

Bubba1 · 12-03-2017, 09:20 PM

If yours are the Ramco mirrors (most likely) the bottom convex mirrors are available from Ramco. I've had to replace both of mine, it's real easy. Even I could do it, at night while coach was parked at my storage lot. My mirrors are the Ramco 9000 series. They may even be available on amazon.

Mike H

Monaco Wolfy · 12-03-2017, 10:11 PM

One solution would be to stop into a auto glass shop. Many have 1/8 mirror in stock. They can trace a paper pattern off your surface. Cut around the paper pattern. Then lay it on the mirror. Trace around it with a fine felt tip pen. Then they can cut it out of the 1/8 mirror. They will also have a wet belt sander to put a nice edge on it. I was in the glass business for many years and have done hundreds of these before. Not a big deal for someone who knows how. Only problem in doing it this way, the factory mirror has a very unnoticeable tint to it. It will make the headlights behind you a little brighter than your old mirror.