Front Slide Height

[Barrier2]

Hi, On my 2001 Dynasty 36' with single front slide I have a question about the height of the Slide.
When looking underneath with the slide extended I noticed that the front beam ( supporting the slide) appears to be at an angle and lower then the rear beam. Is this normal? Does anyone know the correct height of the slide from the ground (travel position, jacks not engaged)? I can see the beams when looking under the slide. This unit has the Hydraulic slide my build sheet says Carefree mod # NB159EM2317. Is there an adjustment if it is lower and not supposed to be? It does open and close fine.
thanks
Robert

[William Willard]

Don`t fix something that`s not broke -- Just be thankful it works -- Bill Willard

[GULFer]

A service manager told me the best way to check the slide height or alignment is to look at the slide when it's in and line up any side graphic or paint stripes. This will tell you if anything has changed since the coach left the factory. If they line up it's good.... Hope this helps...... GULFer