Full wall slide cable adjust location

[larrykathy]

1. Can anyone tell me where the full wall slide (dr side) cable adjust location is. I suspect it's inside the coach and in the center of the slide, up at the top. I just dont want to go tearing into this with out an idea.

2. Problem is the front top-bottom cables have no slop and the cables at the rear of the slide are very loose, 2" slack. With the slide in, the rear of the slide sticks out 2" where as the front is fairly flush.

Just really want to inspect the area.

There is a Accu Slide manual with the coach.

2014 Monaco Ambassador 38PFT

TNX

[blahargoue]

If it's like my Vacationer, it's located behind the fabric trim that that runs above the slide out in the living room. The fabric is held in place with velcro. Pull it off and you will find some small access holes in the wood frame. The motor drive is centered above the room and cables attach to a chain "carraige." The access holes are really too small get your hand and end wrench into. I used a keyhole saw to enlarge mine. The fabric trim covers the enlarged holes.

Bruce LaHargoue

[wa8yxm]

There are two locations..l you cited the most likley, The other one is below the slide, also more or less centered.

On my Accu-Slides,,, There is a "Facia" panel on the top of the slides, a few screws (3 or 4) and it comes off and lays on the bed, The adjustment is behind it.

Suggestion
Go to Home Depot, Lowes, Mennards, Joe's hardware, Et-al and pick up a bag of 1/4" NYLOCK nuts. When I got around to looking at my adjustment area.. I found one or two nuts missing.

Run the Nylocks on the bolts just far enough that threads show TROUGH the nuts (You can run 'em all the way down if you wish but that's a lot of work with Nylock) that way if a nut tries to come off it will hit the Nylock and .... STOP before it vanishes.