Community Forums

Wannabe · 10-20-2011, 01:37 PM

Anyone know where the fuse is located for the on/off 12V DC switch for the TracVision in-motion Satellite? Also when looking at the diagram on the cover of the box in the front driver's side bay, what does the 1st # represent; IE, F1 fuse is shown as 4-1? Thanks for any help!

NicoleAtKVH · 10-21-2011, 08:00 AM

Hi there,

I work at KVH and we'd like to help. Could you please contact our technical support team at 401-847-3327 or by e-mail at techs@kvh.com with your contact information, the serial number of your antenna, and the current symptoms you’re exhibiting?

Thank you,
Nicole

rpasetto · 10-21-2011, 04:06 PM

I don't know if ours is the standard for Monaco but power to our TracVision dome comes from a fuse in the internal 12v fuse box. In the rear closet in our case.

Wannabe · 10-21-2011, 08:16 PM

Quote:

Originally Posted by rpasetto

I don't know if ours is the standard for Monaco but power to our TracVision dome comes from a fuse in the internal 12v fuse box. In the rear closet in our case.

That's where I thought it would be but I don't find anything specifically marked fot Sat TV. How is yours marked?

rpasetto · 10-22-2011, 07:04 AM

Quote:

Originally Posted by Wannabe

That's where I thought it would be but I don't find anything specifically marked fot Sat TV. How is yours marked?

Strangely enough, It's the same fuse that controls the electric toilet, marked accordingly.

Wannabe · 10-22-2011, 08:20 AM

Quote:

Originally Posted by NicoleAtKVH

Hi there,

I work at KVH and we'd like to help. Could you please contact our technical support team at 401-847-3327 or by e-mail at techs@kvh.com with your contact information, the serial number of your antenna, and the current symptoms you’re exhibiting?

Thank you,
Nicole

I appreciate the offer, but at this time I'm just trying to locate a fuse that Monaco would have installed.
It's good to know that KVH monitors these forums, and I will contact you again after I install the 15V DC power supply that I bought using your part # to provide a more consistent voltage.