Leveling sequence for Holiday Ramblers

[JimM68]

Originally Posted by ahicks

I looked at the back of the actual parking brake knob/control. The only thing there are air lines. No electrical at all. So this has to be wired into a pressure switch somewhere?

must be a switch somewhere, it lights a light on the dash when the ebrake is on.

[deSanford]

It seems to me that the same "12 volt dc Juice" that lights the light can be used to send a signal to the slide that it is OK to come back in.

[ahicks]

Originally Posted by deSanford

It seems to me that the same "12 volt dc Juice" that lights the light can be used to send a signal to the slide that it is OK to come back in.

That would sure make things easier, for me anyway. The problem with mine (a '97) is the coach has no light indicating the brake is on?

I'm sure the system can be modified a little to make this change, and adding a "brake on" light on the panel would likely be part of a good plan. I have the prints, it'll just be a matter of tracking the switch down on the print, then getting ambitius enough to want to crawl around underneath it, locate the switch, and then do the mods.

I was just thinking that if somebody had "been there, done that" already, they might be able to save me a little time and trouble. Being lazy...

[deSanford]

I can't tell you how to do it as then it would become a liability issue. I can tell you if there is a way (there is) then there might be a will.