Magnum remote

junglturbine · 03-20-2011, 01:50 PM

I am having a problem with my Magnum remote not reading coming back from the inverter in my 2007 Dynasty. The inverter is working well but no indication on remote panel. I have tried all the connections and they appear good. I sthere an external fuse or something else I should check.
Thanks

bullheaded · 03-20-2011, 01:56 PM

Had this issue on an other coach. Unplug it and plug it back in.

Diplomat Don · 03-20-2011, 08:59 PM

jinglturbine......Go to the inverter and disconnect the cable that looks like a phone line. Wait 30 seconds and reconnect. That should solve your issue.

MonacoMama · 03-20-2011, 10:57 PM

Quote:

Originally Posted by Diplomat Don

jinglturbine......Go to the inverter and disconnect the cable that looks like a phone line. Wait 30 seconds and reconnect. That should solve your issue.

Don...I believe there are 3 connectors that look the same as a phone jack. You would want to unplug the middle one if that is the case. (Ours is the blue color coded cord).

MonacoMama · 03-21-2011, 12:09 AM

This is from the Magnum website:

Quote:

4.4 Resetting the Inverter
Under some fault conditions (e.g., an internal fault), the inverter will need to be reset.
To reset the inverter:
Press and hold the Power ON/OFF pushbutton (see Figure 4-1) for approximately fi fteen (15)
seconds until the Charging/Inverting Status LED comes on and fl ashes rapidly; once the rapid
fl ashing has begun, release the Power ON/OFF pushbutton. The Status LED will go off after
the pushbutton is released.
After the inverter reset is completed, press the ON/OFF pushbutton to turn the inverter ON.
Info: The Power ON/OFF pushbutton is a small momentary type switch which operates
by lightly pressing and releasing.