2003 Monaco Knight right front brake caliper won't completely release brake pads. Two new calipers/pads and bleeding of front brakes doesn't correct problem. A Monaco Tech mentioned that a modulator control assembly that is between the master cylinder and the calipers as a potential problem and he thinks it's mounted on the chassis above one of the storage bins but didn't know which one? Does anyone have an idea of the location of this modulator assembly? (This has been an ongoing overheat problem of the RF brake assembly) I would appreciate any help on this.
OldBuddy
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
My ABS module is located in my smaller compartment where the water heater, inverter, transfer switch, and water pump & manifold. It is mounted to the ceiling. I found it when I installed my surge guard next to the transfer switch. It had a label on it.
Here is a link to one with the same part # as mine.