Mystery Sensor

[moisheh]

The photo is of a sensor that is located behind the stainless door in the service bay. It has 5 wires, velcroed to the inner wall of the bay and has a blinking red LED. The Monaco tag says it is either a fill level 2 or full level 2 sensor. What is this??

Thanks

[moisheh]

The photo is of a sensor that is located behind the stainless door in the service bay. It has 5 wires, velcroed to the inner wall of the bay and has a blinking red LED. The Monaco tag says it is either a fill level 2 or full level 2 sensor. What is this??

Thanks

[HPH]

Strickly a guess, maybe some type of thermister to measure bay temp.

[-Gramps-]

It looks like a tank fluid level sensor to me.

[moisheh]

Cannot be a tank sesnor as it is not attached to a tank. ???

[Rocky Larson]

It looks like it can be unplugged? If so I would do that and then check all the monitors and readouts. Does the LED go off when you hit the 12 volt disconnect? Shielding it with a couple layers of aluminum foil may also show if it is sending a signal somewhere.
Good Luck
PS: You don't have a history with any three lettered government agencies do you...?

[Freemn2]

Could it be the temperature sensor for the bay heater? If it is blinking, see if your bay heater is on.....?????

[moisheh]

Rocky Larson:

Good sense of humour!! I was thinking of some spy movie when I saw that sucker blinking. Maybe Bourne Conspiracy!!!