New thought on monaco curise control problem

[asheville]

Previous post, 2006 Monaco signature curise control light in dash says ON, but aladdin system says OFF and it will not set. I have pushed all buttons, turned jake off, still will not set?Electric drawing shows5amp fuse , can't find it?However,between the time the curise worked and now , my house battries did go down , I had them checked, they where ok but my chassie battries where low so I had them replaced!!!I would think the curise operates of chassie battries? Does any thing need to be reset?? I just think I'm missing something simple, thanks for all the help

[FLYING BUTCH]

may not be your problem but I had my toad wired up by mechanic who didn't use the wireing harness I brought to him. His wireing allowed the flow of electricity to backflow from the toad into the coach which made the cruise control to "read" the coach brakes were on. With it reading the brakes were on the cruise wouldn't enable. Again may not be your problem but check your brake control switch to make sure it isn't getting a backfeed. Good luck

[asheville]

Butch, you may have something there! now that I think about it, my tow car lts would not work? Same tow package off my old MH, just assumed it is wired the same?Was traveling day time and did not know they didn't work til I hooked up , did not have time to screw with it.Am planning to get new wiring harness next wk anyway, it had give me a few problems from time to time. Thanks for the idea