Oil pressure gauge goes to 0.

[YC1]

Thanks guys. Harry, I think it needs a fresh coat of wax right there.




Ok, I like my chassis clean too. I found the trigger part for my pressure washer to use in place of the long wand. The short handle uses the same nozzles. Cleaning as I move around to grease things up was really nice. A long pressure washer hose make things nice.

I have an electric powered pressure washer that has been modified to fit in a small compartment. It only cycles on when the trigger is pulled so I don't have to listen to the noisy gas unit. It does not have quite the ump but sure does a good job cleaning the grease off things.

An on demand hot water heater would be really nice to feed it with. Well, I digress.

Thanks everyone. I will check it out today.

[RustyTools]

You know what they say: "Clean engine, dirty mind." Or was it the other way round? .

Oh, but to wish I could keep mine stuff like that as clean - I just tell my wife that "it isn't leaking, it's just marking its territory"

[YC1]

I manged to find it thanks to the suggestions. It was a bit of a pain to remove the connector.

It is held on by two locks on mine. Once removed I found one of the pins looking a bit suspect with some possible contamination. It is clean and tight now and at least I have the information I needed about how it works. That is, it has two outputs which is very interesting.