Power Cord Fuse for 2008 Dynasty

DCTENT · 05-02-2008, 10:36 AM

My Power Cord will not go in on My 2008 Dynasty,, Anyone know where fuse would be?. cannot find it in manual.

DCTENT · 05-02-2008, 10:36 AM

My Power Cord will not go in on My 2008 Dynasty,, Anyone know where fuse would be?. cannot find it in manual.

Robin_M · 05-02-2008, 12:20 PM

Try the Front Run Bay (under the driver). On my Dip, it's fuse #36 in there. No guarantee it's the same on the Dynasty, however, as that's a whole different animal.

MonacoMama · 05-02-2008, 12:32 PM

...and if that doesn't work ...then I would have your coach number handy and call
Monaco Tech Support Phone: (877) 466-6226

MM

DCTENT · 05-02-2008, 01:17 PM

I have LOOKED at fuses in Front Electrical Run Bay, They are all Labeled by name, I found nothing for Power Cord.
Guess I will call support,
Thanks Guys!.

Oh-one · 05-02-2008, 05:01 PM

Do you have a small reset switch above the power cord switch in your bay?

DCTENT · 05-03-2008, 02:37 AM

NEGATIVE on the reset switch, I did Ck with Monaco Support, They informed Me fuse is located in REAR fuse panel, DAH to Me!!!!

cb5300 · 05-03-2008, 08:09 AM

On my 2007 Dynasty (Diamond floor plan) the fuse is inside the service bay. There is a panel that you open to get to your water block,water hose ,etc, the wires right against the front panel will have a fuse holder and that was the fuse for my power reels. I think it's a 10 amp fuse??? It also controled the lights in the service bay.