Removing Service Bay Access Panel, to reach Sani-Con

[slsbuz]

08 Beaver Contessa

What is the degree of difficultly in removing stainless steel wall panel that cover access to my Sani-con system. Would like to check system hoses for blockage and I see no other resaonable access. This panel has water back fill connector, water service selector levor, paper towel rack, electroic monitor gage displaying tank levels, connectors for cable/sat TV and access for water hose power reel and maybe more.

The first time I looked at this I was stopped in my track, too many thing to go wrong. Need some advise on how to proceed without making this a bigger job then it really is, would appreciate some ideas.

[wa8yxm]

From the outside it looks daunting.. Same as it does on my Intruder (only it's plastic)

turns out on my rig at lest you get it loose (Remove the screws) you can reach being and undo two QUICK CONNECT fittings (like hose fittings) and the only thing left is the back flush hose. that's fairly long and was also easily disonnected.

Good luck with the Sanicon Let us know how it turns out.

[William Willard]

Take a closer look at the location of your SaniCon -- You can probably reach, & remove it without taking the panel off --The motor should be where you can access it, if the impeller gets pluged -- You can relocate it easy enough -- I have a Camelot, & the SaniCon was buried like yours - There are some pictures in this forum somewhere of this mod -- Bill Willard

[William Willard]

Found the picture --