 |
Replacing shower valve 03 Dip.
01-15-2012, 11:54 AM
|
#1
|
|
Member
Monaco Owners Club
Join Date: Nov 2009
Location: Arlington, TX
Posts: 41
|
Before I try tearing apart the shower, I thought I would see if anyone out there has ever replaced the shower valve assembly.
There is no access to the rear of the shower in my 03 40' Dip PWD. I need to replace the shower valve assembly because it is leaking behind the assembly. The water rips in the wet bay off the lines leading to the shower.
Has anyone tackled this job?
__________________
Richard 
2003 Diplomat 40 PWD
|
|
|
|
| |
|
 |
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
01-15-2012, 12:39 PM
|
#2
|
|
Junior Member
Monaco Owners Club
Join Date: Oct 2011
Posts: 17
|
I, of course don't know your floor plan, but on our 03 HR Ambassador I had the same problem. Our front driver's side slide has the galley at the far end of the slide with a upper and lower pantry. In the back of the upper pantry is the access panel for the shower when the slide is out. It turned out that the plastic fittings on the back of the shower were loose and leaking. I just tightened them up and have had no problems since.
Good luck,
Al
__________________
|
|
|
|
| |
|
01-15-2012, 04:29 PM
|
#3
|
|
Senior Member
Join Date: Apr 2010
Posts: 258
|
I too have an access panel in the cabinet behind the shower in my 07 Beaver Contessa. So I'm no help to you.
Ken
__________________
|
|
|
|
| |
|
01-15-2012, 05:31 PM
|
#4
|
|
Senior Member
Monaco Owners Club Texas Boomers Club
Join Date: Feb 2008
Location: Denmark and US
Posts: 946
|
In our 07 Dip there is no immediate access. We asked a couple of the Monaco Tech's, how we could replace the shower fauset, when we visited the factory in Oregon, and here is their answer:
"Emmmm - we don't know. Maybe if the kitchen was removed....".
For that reason we still still have the original fauset installed.
__________________
The Great Dane
2007 Monaco Diplomat PAQ - 2007 Saturn Vue
Living in Denmark - visiting the US whenever possible. Honorary Texas Boomer www.monacocoach.dk
|
|
|
|
| |
|
01-15-2012, 06:39 PM
|
#5
|
|
Senior Member
Monaco Owners Club
Join Date: Feb 2011
Location: Signal Hill, California
Posts: 633
|
Just changed out the shower "control" on our 2011 Navastar Monaco Cayman with an American Standard unit. Panel was located in the master suite. When you change out the "old" unit you will see why it works the way it "works. No more need to be said.
__________________
Sanford, Linda & R cats: Molly, Levi, Cody
2011 Navastar Monaco Cayman 
2002 Mini Cooper:goes where it's towed
|
|
|
|
| |
|
01-15-2012, 07:48 PM
|
#6
|
|
Junior Member
Join Date: Jul 2008
Posts: 27
|
Hello - I have an 02 Windsor PKD and the 'back' of the shower is against the galley side. To get to the shower valve, I had to remove the first two mirrors that behind the stove top. They were held on with silicone.
Alan
__________________
|
|
|
|
| |
|
01-16-2012, 08:06 AM
|
#7
|
|
Senior Member
Monaco Owners Club
Join Date: Jul 2006
Location: Cornville, AZ
Posts: 747
|
I think in all cases there is an access hole to get to the shower valve. The problem is Monaco hides it in a cabinet or behind mirrors or other wall coverings. In my 06 it was behind a Corian panel that was held to the wall using double sided tape. We had to use a long thin pick of metal to break all the tape lose. The panel is now attached with heavy duty Velcro.
__________________
Dave & Jeri
06 Holiday Rambler Endeavor
TOAD 11 Honda CRV
|
|
|
|
| |
|
01-16-2012, 09:25 AM
|
#8
|
|
Member
Monaco Owners Club
Join Date: Nov 2009
Location: Arlington, TX
Posts: 41
|
Thanks for the replies.
My Dip has the galley in the drivers side slide. There is a buffet behind the shower. I looked behind the drawers and the upper cabinet but no access there. I guess it could be behind the mirror panel. Will have to see if DW will allow me to try and remove the mirror.
__________________
Richard 
2003 Diplomat 40 PWD
|
|
|
|
| |
|
01-16-2012, 10:41 AM
|
#9
|
|
Senior Member
Join Date: Nov 2010
Posts: 288
|
Richard. I thank that if it has a removal panal, it will be right behind the shower control. Do a little measuring and you should find it. Like others have said it maybe be covered up. In my 06 Dip, it is on the bedroom wall, when we got the coach it was just a panal held on with 4 screws. We covered ours with a then photo frame attached with mirror mastic.
If you do find something that you think covers the whole you can use good fishing line to assist in cutting the mastic or silacon to remove it. Just take your time and it is easy. Hope this helps you out.
__________________
George & Julie
06 Diplomat PDQ
|
|
|
|
| |
|
 |
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
|
| Thread Tools |
Search this Thread |
|
|
|
| Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|

»
Recent Discussions

»
Upcoming Rallies
No events scheduled in the next 365 days.
|
»
iRV2 on facebook
|
Copyright 2002-2012 Social Knowledge, LLC All Rights Reserved.
All times are GMT -6. The time now is 04:45 AM.