I just upgraded from the stock Magnaydyne 9900DVDS to a Magnadyne M3-LCD. Easy switch over using the same harness and dash can. The problem I have is the front speakers do not work. I'm assuming there is some type of conflict with the River Speaker Park switch (#6CHXOV-01). I switched back to the 9900 and the front speakers work fine, so I know the switch is good.
Any ideas are appreciated.
Thanks in advance.
Mike G.
2008 Camelot 36 PDQ
__________________
Mike G
2019 Newmar Dutch Star 4018 - Freighliner
2022 F150 Platinum or 1973 Toyota FJ40
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Got it resolved.
The River Park speaker switch needs 12V from the dash radio to turn on the front speakers. That power typically comes from the blue "Remote" wire on the radio harness of the 9900DVDS to pin #5 on the speaker switch. The M3-LCD blue remote wire is a stand alone and not in the harness plug. I soldered the blue remote wire from the radio to the harness and all works well and sounds great.
Thanks for your response itdave.
Best,
Mike
__________________
Mike G
2019 Newmar Dutch Star 4018 - Freighliner
2022 F150 Platinum or 1973 Toyota FJ40
I'm assuming there is some type of conflict with the River Speaker Park switch (#6CHXOV-01). I switched back to the 9900 and the front speakers work fine, so I know the switch is good.
Linear Mode
