Slide roller adjustment on 2000 Knight

[Rayhough]

Does anyone have instructions or a link to instructions for adjusting the slide rollers on a 2000 Monaco Knight? The slide binds slightly on one end. I found the adjustment nuts but havn't played with them yet. Thank you. Ray

[WeBeGone2]

Which slide. Depending on slide some have two motors others have single. Bedroom or large front slide.

[Rayhough]

Only has the one kitchen slide one motor operating 2 gear drives. It has at least 3 adjustable rollers.

[WeBeGone2]

Don't think I can help on this. Sorry. Mine was the small direct drive in bedroom. Ended up being steel rollers that ran the main toothed track. One of the steel rollers (there are 4) sheared off and caused the entire slide to skew when operated.

[walt2137]

Ray it's Ben a while but the procedure I used on a 99 Dip was to put the slide about 1/3 out and back off all the way on adjustment screws (good time to clean the rollers ) adjust the set screws until it barley touches after you get all touching then tighten 1/2 to 3/4 turn more also a good idea to use loctite on the jam nut.

[Rex]

Ray, adding to what Walt told you, two of the rollers are accessed inside your cabinets. They are the rear and center roller and move with the slide if they are like my Diplomat. The front roller is stationary and can be accessed through the drivers front wheel well. There is a plastic cover over it that must be removed.

[38 Special]

If power Gear, there are instructions on their web site. Easiest way to align is to look at the paint lines outside, they would be straight when it left the factory.