Water Pump Switch light Replacement

[Corvette Man]

2007 Monaco Knight . The light at the sink water pump switch has burned out. How do I replace it? I can pull of the light cover but don't know how to pull the bulb. Thanks for your help.

[Dr4Film]

Corvette Man,

I have replaced a few of these on my 02 Windsor. If yours are the same type, you remove the complete bezel panel holding the light and possibly switches. Then remove the two wires attached to the light, and squeeze the two plastic ends to remove the light mount. You can buy these at various RV parts stores including Camping World. They come in different colors both the light and the case.

Here is one source that I use and a photo.

Northwest RV Supply: Lighted Indicator Panel

Good luck!

Dr4Film ----- Richard.

[Diplomat Don]

Corvette Man....I think you were referring to replacing the bulb within that light housing....I read where a couple of people have done it, BUT...it's much easier to just buy the new light assembly. They are relatively cheap to buy.

[tncruiser]

that a standard carling switch you can buy it any auto parts store and save the shipping
brianj

[Mandys Man]

Look here for 07 Switches. They may even be willing to sell to individuals with the way the economy is going. If not, they should be able to point you in the direction to get one.

[Corvette Man]

Thanks for all your help. I think I can get them done. Thanks again.

[Richard Wold]

These units are easy to open. Just pop out the red lense, then solder in a 12 V red LED. Mark the polarity on the back of the housing. For a $1.00 LED you have a light that will never burn out. I have been doing mine as they burn out. Easy 5 min. job.