 |
01-05-2015, 11:32 AM
|
#1
|
|
Junior Member
Monaco Owners Club
Join Date: Jun 2014
Location: Tucson, Az
Posts: 6
|
Where is plug-in for ScangaugeD?
I bought a ScanGaugeD to have more accurate info about the Windsor. One of the selling points is how easy it is to install - just plug it in. I would love to do that, but have been unable to find the data plug-in. I have the panel off of the driver's side console and have looked in all that bunch of wires, but have not found it.
Has anybody else put one in a 2002 Windsor PST so you could tell me where it might be?
__________________
Doug & Sharyl & Aggie & Bibi (Westies)
2002 Windsor, 2014 CR-V
RV'ing since 1992
|
|
|
 |
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
|
01-05-2015, 02:45 PM
|
#2
|
|
Senior Member
Monaco Owners Club
Join Date: Jun 2014
Posts: 14,601
|
Don't know if it is the same but the connector for my Silverleaf system was under the dash, left hand side next to the steering column. Easy to access.
I looked at a Scangauge D and it looks like the same connector
__________________
Jim J
2002 Monaco Windsor 38 PKD Cummins ISC 350 8.3L
2005 Jeep Grand Cherokee w/5.7 Hemi
|
|
|
|
|
01-05-2015, 11:07 PM
|
#3
|
|
Senior Member
Join Date: Feb 2012
Posts: 539
|
On my 02 Diplomat the plug is in the left front electrical bay.
__________________
Bob & Elaine McClelland and the spoiled pup Izzie
2008 Monaco Diplomat
Desert Hills & Parker Az
|
|
|
|
|
01-06-2015, 04:21 PM
|
#4
|
|
Senior Member
Holiday Rambler Owners Club
Join Date: Dec 2011
Location: Iowa
Posts: 730
|
Mine was under the dash on the left side of the steering column. Easy install.
Alan Wilson
2001 HR Scepter 38 PBD
__________________
Counting down the days until our next great adventure!
|
|
|
|
|
01-06-2015, 04:27 PM
|
#5
|
|
Senior Member
Monaco Owners Club
Join Date: Feb 2011
Location: Signal Hill, California
Posts: 3,320
|
X2 what Alan said. Sanford
__________________
Sanford, Linda & R cats: Molly, Levi, Cody
2011 Monaco by Navistar RV
Good Sam Life Member Good Sam Hams Chapter
|
|
|
|
|
01-06-2015, 07:07 PM
|
#6
|
|
Senior Member
Monaco Owners Club
Join Date: Jan 2012
Location: Durant, Ok
Posts: 403
|
like McCrob above, I also have an 02 Diplomat. I have the scan-gauge connector in the drivers side front compartment, but I also have one attached to the left side of the steering column just below the dash.
It is kind of hidden among all the wires but it can be found.
Keith
__________________
2007 40ft Phaeton, Cat 350 hp
Dingy - 2021 Gladiator Rubicon
Keith & Shirley,Durant, OK
|
|
|
|
|
01-06-2015, 07:15 PM
|
#7
|
|
Senior Member
Holiday Rambler Owners Club
Join Date: Dec 2011
Location: Iowa
Posts: 730
|
Quote:
Originally Posted by SunBear
I bought a ScanGaugeD to have more accurate info about the Windsor. One of the selling points is how easy it is to install - just plug it in. I would love to do that, but have been unable to find the data plug-in. I have the panel off of the driver's side console and have looked in all that bunch of wires, but have not found it.
Has anybody else put one in a 2002 Windsor PST so you could tell me where it might be?
|
Sunbeam, I was surprised at how inaccurate my gauges were compared to the scan gauge. It doesn't have fancy graphics or a big screen but it gives you all the information you need. Take a few minutes and commit the terms for each operation to memory so you know in a flash what you are looking at. Myself I run the instant MPG and the average MPG on one side and the engine temperature and depending on if I am in a hot area pulling mountains the transmission temperature. This one I float Round depending on the conditions I am in. Really a nice information center.
Alan Wilson
2001 HR Scepter 38 PBD
__________________
Counting down the days until our next great adventure!
|
|
|
|
|
01-06-2015, 08:27 PM
|
#8
|
|
Senior Member
Join Date: Jun 2011
Location: FL
Posts: 11,452
|
Quote:
Originally Posted by ruffian
like McCrob above, I also have an 02 Diplomat. I have the scan-gauge connector in the drivers side front compartment, but I also have one attached to the left side of the steering column just below the dash.
It is kind of hidden among all the wires but it can be found.
Keith
|
Assisting a friend with his found two ports as well. However the one in the front compartment did not work properly. The device would power up for a few seconds and then go to sleep. Just something to be aware of.
__________________
Certified Senior Electronic Technician, Telecommunications Engineer, Telecommunications repair Service Center Owner, Original owner HR 2008
.
|
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Linear Mode
